How can I hide my small water heater?

Curtains. Perhaps the simplest way to hide your furnace and water heater is to add a sliding curtain as a divider. You will need to measure the wall height to determine proper curtain length, as well as the needed width. Be sure to give a few inches of clearance so the curtain doesn’t touch your heater.

In most instances, a home’s water heater is placed in the basement. When the basement is finished so it can be used for another purpose, leaving the water heater in plain view can detract from the appearance of the room. You can enclose the water heater by building a wall around it and constructing a utility closet.

One may also ask, how can I hide my furnace? Using a curtain to hide your water heater and furnace is perhaps the easiest of all the DIY methods. All you have to do is buy some shower curtain rods that can be mounted from the ceiling, a shower curtain (or some other type of cloth curtain), and a curved connecting pipe.

Hereof, do water heaters need to be covered?

However, the tank must keep its reserve warm at all times to ensure that water is hot when you turn on your tap. A water heater cover acts as insulation for the tank to prevent heat from escaping so that your water heater does not expend as much energy keeping water warm for you.

Are drip pans required for water heaters?

Pans & Drains It’s generally recommended, and required, to install a drip pan with a drain line beneath your hot water heater tank. Especially if you water heater is in your home or basement, a leak could cause lots of water damage. A pan and drain eliminate this possibility.

How much space do you need around a water heater?

The clearance space needed around a hot water heater is dependent upon whether the heater is a gas or electric model. Twenty-four inches of service clearance in front and two inches on the back and sides is recommended for gas water heaters, whereas electric heaters do not require minimum clearance.

Should a water heater be off of the floor?

The Uniform Plumbing Code, which establishes standards nationwide, says that the flame or sparking mechanism in a gas water heater must be at least 18 inches off the ground. This means that an accurate measurement for proper installation is not based on the distance from the bottom of the water heater to the floor.

Can a gas water heater be inside the house?

If your water heater or furnace is in a closet inside your home, there are a few things you can do to make it safe. It’s crazy but for decades building practices allowed furnaces and water heaters to be inside the home. Because natural gas, combustion and potentially carbon monoxide are right inside the home.

How do you move a water heater by yourself?

Moving A Water Heater Step 1 – Turn off the Power. Before you do anything, turn off the breaker switch to the water heater. Step 2 – Turn off the Water Supply and Drain. Before draining the tank turn off the water supply. Step 3 – Disconnect Pipe. Step 4 – Disconnect the Electric. Step 5 – Drain Remaining Water. Step 6 – Maneuver and Transport.

Where can a water heater be located?

Most water heaters are located in the home’s garage, basement, or attic. Water heaters (not including tankless) can take up a lot of space. These areas are usually the best place to store your heater to best accommodate the size.

Where is the air intake screen on a water heater?

The air intake screen (#1) is located at the bottom of the tank. I’m sending you some pictures. The black windows at the bottom of the water heaters on the second picture are the air intake screens. There is also an air intake screen (arrester) under the burner assembly that may need to be cleaned.

Does wrapping your water heater really save energy?

If not, consider insulating your water tank, which could reduce standby heat losses by 25%–45% and save you about 7%–16% in water heating costs—and should pay for itself in about a year. You can find pre-cut jackets or blankets available from around $20. If you don’t know your water heater tank’s R-value, touch it.

Do water heater blankets work?

Will a Hot Water Heater Blanket Save Money on my Energy Bills? The short answer is yes, because it maintains a consistent internal temperature—meaning the hot water heater doesn’t have to work hard to raise the temperature of the water, especially with conventional hot water heating tanks.

Can you put a blanket on a gas water heater?

An insulation blanket is not recommended for a water heater located where its lost heat could be utilized. Here’s how to wrap your water heater with an insulation blanket: If you have a gas water heater: Wrap your gas water heater all the way around and from the top to just below the controller.

How do you service a water heater?

Flush the Tank Turn off the electricity to the water heater or turn off the gas to extinguish the pilot. Connect a garden hose to the tank’s drain valve. With the pressure relief valve open, open the drain valve and allow the tank to drain completely.

How can I make my water heater more efficient?

7 Ways to Make Your Hot Water Heater More Energy Efficient Turn Down Your Thermostat. Invest in a Tankless Water Heater. Make Sure You’re Using the Right-Sized Water Heater. Keep an Eye on Your Tank’s Sediment. Insulate Your Water Tank and Pipes. Install in a Volt Timer. Use Less Hot Water.

Can you put a timer on a hot water heater?

A water heater timer is a small electronic device that fits onto your current hot water heater (either gas or electric), and allows you to set specific “on” or “off” periods for hot water production and maintenance.

Do water heater timers really save money?

The amount of money that your water heater timer will help you to save depends on the standard running cost of your water heater, the water heater and fuel type, and your hot water consumption. Water heater timers have been found to save up to 25% on the annual costs of water heating.