How do you remove Axor Hansgrohe?

The fittings from the Axor lines Axor Terrano, Axor Carlton, Axor Citterio, Axor Citterio M, Axor Montreux, Axor Uno or Axor Uno² can be uninstalled by pushing a pin through the hole using a thin object, e.g. an allen key (2 width A/F), while simultaneously pulling the holding part forwards.

How to Remove a Grohe Handle Shower Temperature Control

  1. Find the small screw on the handle’s bottom and take it out with an Allen wrench.
  2. Unscrew both trim plate screws with a screwdriver and pull the screws out of the trim plate.
  3. Pull the faucet’s cover off.
  4. Slide off the small part on the cartridge’s top.

Additionally, how do you remove a faucet handle? If your faucet has a decorative cap, pry off the cap with a small flathead screwdriver, then remove the handle screw with a Phillips screwdriver. If your faucet has a setscrew, remove the setscrew with an Allen wrench. Pull straight up on the handle to remove it from the faucet body.

Also Know, how do you take apart a Hansgrohe shower handle?

How to Disassemble a Grohe Shower Valve Handle Lever

  1. Turn off the water that flows into your shower by closing the incoming water line in the home.
  2. Find the handle lever’s set screw.
  3. Take out the screw once it is completely unscrewed and set it in a place where you won’t lose it.
  4. Pull on the handle to slide it backwards and off of the faucet stem.

How do you take apart a Grohe faucet?

Turn off the water supply to the faucet at the shutoff valves under the sink. Loosen the nuts securing the hot and cold water lines to the faucet handle stems under the sink with a wrench. Pull away and remove the water lines from the faucet.

How do you adjust the water temperature on a Hansgrohe shower?

Turn the rotational limit stop, clockwise to make the water cooler, counter-clockwise to make it warmer. Depending on local conditions, each notch represents a change in temperature of 4°F – 16°F.

How do you replace a shower temperature control valve?

How to Replace a Shower Temperature Control Valve Step 1: Removing the Cover. The first step is to remove the screw cover from the center of the shower faucet handle. Step 2: Removing the Handle. Step 3: Removing Escutcheon Plate. Step 4: Turning Off Water Supply. Step 5: Removing the Bonnet Nut and Cartridge Assembly. Step 6: Installing New Cartridge.

How do you tighten a Grohe shower handle?

How to Adjust Grohe Shower Faucets Turn off the water to your shower faucet. Remove the handle to the shower faucet. Remove the temperature control knob, which is the round, dial-shaped fitting over the faucet cartridge. Turn on the water and rotate the adapter to the left, or counter-clockwise, until the water temperature is at the level you want.

How do you remove a screw from a shower handle?

Unlike most screws, faucet set screws are too soft for screw extractors. Insert a cobalt drill bit into your drill. Drill through the center of the head until the bit is slightly below the bottom of the screw head. Position the drill bit over the the first hole and drill out the screw head.

How do you fix a Grohe shower faucet?

How to Fix a Grohe Shower Cartridge Turn off the main water knob. Use your hex keys on the faceplate of the shower to remove it. Attach your channel locks to the shower cartridge. Use your right hand and the hex key to unlock the two shower knobs by turning counterclockwise.