How do you start a Troy Bilt 875exi pressure washer?

If you cheap out, you will probably get a junky tool but in this case we feel that for the price, there is terrific value and many great features. Sure you will not be cleaning a three story house with it but for most home owners the Troy Bilt Pressure Washer is a great tool to have around.

Troy-Bilt Pressure washer won’t start

  • Spark Plug. Inspect the spark plug for signs of wear or damage.
  • Carburetor. The carburetor might be clogged.
  • Ignition Coil. The ignition coil sends voltage to the spark plug while the engine is running.
  • Flywheel Key. the flywheel key might have sheared in half.

Secondly, are Troy Bilt pressure washers good? If you cheap out, you will probably get a junky tool but in this case we feel that for the price, there is terrific value and many great features. Sure you will not be cleaning a three story house with it but for most home owners the Troy Bilt Pressure Washer is a great tool to have around.

Also question is, what would cause a pressure washer not to start?

A Dirty Air Filter They filter the air so that the engine and pump does not get clogged up with outside debris. If the air filter is too dirty and clogged up, the engine won’t be able to suck in enough air to keep cool. In extreme cases, this can actually cause the pressure washer not to start at all.

Can you start a power washer without water?

Why You Should Never Start a Pressure Washer without Water Although you can start a pressure washer without water, it is not advisable to do it. When you start a pressure washer without water hooked to it, you are taking a huge risk. The damage will be immediate and devastating to the pressure washer’s inner workings.

How do you fix a pressure washer that won’t start?

Your Engine Won’t Start or is Lacking Power Run water through pressure washer until all air is removed from the hose. Check your air filter. Clean if dirty and replace if damaged. Check oil level. Change if needed. Top off fuel in tank. Make sure your spark plug is connected to the wire. If your engine was smoking:

What kind of fuel does a Troy Bilt pressure washer use?

Though Troy-Bilt is known more for its lawn tillers and mowers, the company also produces a series of pressure washers. These pressure washers are powered by gasoline engines and have fuel tanks ranging from 1/4- to 1/3-gallon capacity.

Can you flood a pressure washer?

Flooding the engine means too much fuel is in the cylinder and may not fire. This also causes the spark plug to get wet in many cases. Because of this, do not pull the pull cord more than three times with choke engaged or you will risk flooding the engine. Too much fuel and a wet spark plug = NO START!

Why does my Troy Bilt not start?

The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. This sticky fuel can clog up the carburetor and prevent the engine from starting. If the carburetor is clogged, try cleaning it with carburetor cleaner.

How do I fix my Troy Bilt pressure washer?

How to Troubleshoot the Troy-Bilt Pressure Washer Replace the low-pressure spray tip with a high-pressure spray tip. Check the water inlet for blockages and clear the inlet if you discover blockages. Check the inlet hose and verify that the unit is receiving adequate water flow. Check and clean the inlet hose screen.

How do you clean the carburetor on a Briggs and Stratton pressure washer?

Clean your Carburetor in 10 Simple Steps Step 1: Remove the spark plug cap so the engine doesn’t fire. Step 2: Next, drain the fuel. Step 3: If the carburetor bowl has a sticky residue in it, spray the inside with carburetor cleaner and wipe it clean. Step 4: The main jet’s passage is where fuel flows through the carburetor into the combustion chambers.